** End of Life Product **
See these other CalAmp products:
LandCell 882™
LandCell 819-GPRS







IP LAN Ethernet Cell - Cellular Modem

 
 
The new Land-Cellular CDM-822seu CDMA-1xRTT cellular modem is a Full Ethernet Routing Modem with DHCP Server and NAT. Supports devices such as Ethernet web cameras. Powered by an ARM-9 Processor with Embedded Linux at 180 MHz with 8MB of RAM and 8MB of Flash.
 
CDM-822seu - Serial, Cell Ethernet Full Routing Data Modem
M2M / Telemetry Cellular CDMA Modem: Land Cellular Reliable CDMA Products: M2M / Telemetry Cellular CDMA Modem: Land Cellular Reliable CDMA Products:
  • Full Ethernet Routing with DHCP Server and NAT
  • Full ARM 9 Processor
  • 8 MB of Flash with 4 MB of Data Storage
  • Dual USB Host Connectivity for Security Cameras
  • HTML Configuration Utility
  • Supports SIP, MIP and VZW DMU
  • Dynamic and Static IP


  • Spec Sheet
     
    Model CDM-822seu Ethernet Cellular Routing CDMA Modem
     
    Key Features:
    • Embedded Linux on ARM9 Processor
    • Full Ethernet Routing (Inbound/Outbound)
    • Full Internet Access, web-browsing, etc via Ethernet connector
    • DHCP Server
    • Inbound IP termination with Static IP (Carrier Dependent) or Reverse DNS lookup for Dynamic IP
    • Inbound port mapping/translation to Ethernet connected devices (NAT)
    • Inbound Internet access can be restricted to an optional “Friendly” IP address.
    • Always On Auto-Connect to 1xRTT network with Packet Data connection and with an optional direct Socket Connection to the IP address of your server.
    • Configuration via Web Page or extended AT Command set
    • TCP/IP Packet Assembler and Dissassembler for serially connected devices using ASCII
    • 1xRTT Dynamic or Static IP, Mobile IP, DMU (Carrier Dependent) · AGPS
    • Optional Dual USB Host Controller
     
    Applications:
    • Wireless Internet Backup/Replacement for Wire-line Internet Access at speeds up to 153 kbps
    • Remote Wireless Security monitoring systems with Ethernet cameras
    • Print documents over Internet to Ethernet Printer connected to the CDM-822seu Ethernet jack
    • Wireless POS interface using Ethernet connector
    • Wireless ATM interface
    • IP Based Security monitoring for advanced Security Panels; uninterruptible wireless alarms and continuous status checks by Alarm Company
    • Real time data acquisition using Wireless Internet Traffic light control
    • Reading and routing electric power/gas/water meters
    • KIOSK / Lottery machine remote access
     
     
     

    Interface Connectors
    • RS-232 DE-9S Connector (DCE) 10/100 Base-T Full Duplex
    • Dual USB Host Controller (Optional)
    Power Connector
    • 2.1mm/5.5mm DC Barrel Jack (Center Positive)
    LED Indicators
    • 1xRTT, Tx/Rx, DCD, RSSI
    Antenna Interface
    • 50 ohm SMA Female for Cellular Network
    • 50 ohm SMA Male for GPS Antenna
    Size
    • 5.5” L x 3.1” W x 1.7” H
    Weight
    • 0.55 lb
    Power Input
    • 8-28 VDC @ 1.2W (Dormant, 100ma @ 12VDC)
    • 8-28 VDC @ 3.36W (1XRTT Call, 280 ma @ 12 VDC)
    RF Power
    • CDMA: 200mW (EIRP Nom.)
    • Maximum Tx Power: CDMA: +23.5 dBm min. / +22.5 dBm min (1900MHz)
    Rx Sensitivity
    • CDMA: >-104 dBm
    Frequencies
    • Cellular: Tx: 824-849 MHz Rx: 869-894 MHz
    PCS
    • Tx: 1850-1910 MHz Rx: 1930-1990 MHz
    Temperature
    • Operating:
      -30°C to +60°C (-22° to 140°F) 100% Duty Cycle
    • Storage:
      -55°C to +85°C (-67° to 185°F)
    Operating Humidity
    • 0 – 85% (non-condensing)
    • Transport Protocols UDP/TCP
    Command Protocol
    • Web Interface, Command Line Interface v.250 AT and proprietary commands
    Communication Speeds
    • Serial Interface Data Rates from 300 BAUD to 230,400 BAUD
    Certifications
    • CDG 2 tested and approved FCC ID: RD5-LCC0308 Industry Canada ID: IC: 418A-LCC0308
     
     
    View Other Cell-Cellular Modem Products