|
DSP Based Radio Receiver only Modem IGM-AWRx100 | |
For a printer-friendly PDF click HERE |
|
| AW100Rx: VHF 150 – 170 MHz
DSP based Radio Modem for "receive only" with Built-in wireless link Monitoring and Management Tools: See the IGM-AW100 for the Transmitter - click HERE |
|
|
|
| ArWest Communications Corp. exceeds established standards within the SCADA and outdoor telemetry
markets with the release of AlphaWave100Rx (AW100Rx) series DSP based integrated wireless modem,
the first in a series of next generation Narrow-Band products. The AW100Rx radio modem provides a
high-speed Point-to-Point and Point-to-Multipoint wireless data transfer at up to 38.4 kbps.
AW software supports user selectable modulation techniques (BPSK, QPSK, 8PSK, or 16QAM), which
allows the user to achieve the highest data speed for a given range (up to 50 miles). It also includes a
selectable error correction, which improves the functioning of the radio modem under interference.
The unmatched features of AW100Rx include data scrambling, frequency hopping, user selectable low
power consumption sleep modes, and plug-and-play installation. The built-in software tools provide wireless link testing, unit’s status and error statistics monitoring—as well as unit’s settings change over the air. The software of the AW radio modem resides in a flash memory. The updating of the radio modem programs is entirely software-based. The flash memory is reprogrammable through an serial interface. |
|
![]() |
|
| Parameter | Specification |
| Operating Frequency Range | 150 - 170 MHz |
| Modulation Technique | DBPSK, DQPSK, D8PSK and D16QAM |
| Radio Protocol | Time Division Duplex (TDD) |
| Time Division Multiplex Access (TDMA) | |
| Maximum Distance Range | 50 miles / 80 km |
| Occupied Bandwidth | 6.25 kHz, 12.5 kHz or 25 kHz |
| Data Rate | 25 kHz CS |
12.5 kHz CS |
6.25 kHz CS |
|
| DBPSK | 9600 |
4800 |
2400 |
|
| DQPSK | 19200 |
9600 |
4800 |
|
| D8PSK | 28800 |
19200 |
7200 |
|
| D16QAM | 38400 |
28800 |
9600 |
|
| End to End Delay | 60 ms |
| Standard External Connector’s Pin Layout | ||||
| Pin# | Signal Name | Signal Type | Signal Description | |
| 1 | GND | GND | Signal and Chassis Ground | |
| 2 | TXD | TTL Input | Transmit Data | |
| 3 | RXD | TTL Output | Receive Data | |
| 4 | DP/MP | TTL Input | Data/Maintenance Port selector | |
| 5 | RTS | TTL Input | Request to Send | |
| 6 | SLEEP | TTL Input | Sleeps/Wakes radio receive only | |
| 7 | DCD | TTL Output | Data Carrie Detect | |
| 8 | CTS | TTL Output | Clear to Send | |
| 9 | DSR | TTL Output | Data Set Ready | |
| 10 | RESET | TTL Input | Resets the Radio | |
| 11 | TTLOUT1 | TTL Output | TTL Output Line 1 | |
| 12 | TTLOUT2 | TTL Output | TTL Output Line 2 | |
| 13-15 | Reserved | N/C | Not connected, reserved for future use | |
| 16 | PWR | Power | Regulated positive 3.3 VDC from external power supply | |
![]() |
||||
![]() |
||||
| Other Wireless Unlicensed Data Radio Modems | ||||


